Remote Starter User Manual

12 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved.
39. Wrap the vehicle 7-pin connector with one foam
cushion tape, then place the vehicle 7-pin
connector into the gap of the column.
6D01111T
VEHICLE 7-PIN
CONNECTOR
(brown)
(Squeeze into
this area.)
FOAM
CUSHION
TAPE
VEHICLE 7-PIN
CONNECTOR
VEHICLE
BRACKET
VEHICLE
HARNESS
LOCK
ENGINE
STARTER
HARNESS
WIRE
TIE
VEHICLE
HARNESS
4 WIRE
TIES
GREEN
TAPE
ENGINE STARTER
HARNESS
42. At the right of the steering shaft, locate the sub
joint box. Using a small flat-tip screwdriver, unplug
the vehicle 6-pin connector from the sub joint box.
Plug the engine starter harness 6-pin connectors
into the vehicle 6-pin connector and the subjoint
box.
43. Attach the relay blocks and fuse case on the relay
bracket.
44. Secure the engine starter harness to the vehicle
harness using a wire tie.
6D01063T
RELAY BRACKET
STEERING
COLUMN
SUPPORT
BRACKET
STEERING COLUMN
SUPPORT BRACKET
BOLT (Reuse.)
6D01162T
VEHICLE 6-PIN
CONNECTOR
ENGINE STARTER
HARNESS 6-PIN
CONNECTOR
FRONT
SUB JOINT
BOX
VEHICLE 6-PIN
CONNECTOR
VIEWED FROM
UNDERSIDE
6D01302T
FUSE
CASE
RELAY BRACKET
ENGINE STARTER
HARNESS
RELAY
BLOCK
WIRE
TIE
VEHICLE
HARNESS
40. Secure the engine starter harness to the vehicle
harness with four wire ties in the areas shown.
The lock of the wire ties should face up.
41. Remove the lower steering column support
bracket bolt. Attach the relay bracket to the
steering column support bracket and reinstall the
steering column support bracket bolt.
www.collegehillshonda.com