Remote Starter User Manual

ManualsBrandsHonda Automobiles ManualsRemote Starter08E92-SNA-100B

60. Check that all wire harnesses are routed properly

and all connectors are plugged in.

61. Reinstall all removed parts. Check that all clips

and other fasteners are installed securely. Take

care not to pinch the airbag with a clip during

reinstallation of the front pillar trim. Do not push

the front pillar trim excessively.

62. Reconnect the negative cable to the battery.

Check that the electrical accessory and other

electrical systems function properly.

63. Perform REMOTE ENGINE STARTER

REGISTRATION, on pages 18-20, and FUNCTION

CHECK, on page 21.

64. Enter the customer’s radio anti-theft code, and

reset the radio station presets.

65. Reset the clock.

59. Attach the engine starter label to the back of the

hood.

6D01312T

ANTENNA CABLE

TERMINAL

(Connect first.)

FRONT

CONTROL

UNIT

ENGINE STARTER

HARNESS 18-PIN

CONNECTOR

CONTROL UNIT

BRACKET

7401020T

VEHICLE

HARNESS

WIRE

TIES

ANTENNA

CABLE

58. Using isopropyl alcohol on a shop towel, clean the

area where the engine starter label will attach.

56. Install the control unit on the control unit bracket.

57. Bundle the excess antenna cable with two wire

ties and secure it with one wire tie to the vehicle

harness.

6D01421T

ADHESIVE

BACKING

ENGINE

STARTER

LABEL

HOOD

Installing the Control Unit

55. Connect the antenna cable terminal and the

engine starter harness 18-pin connector to the

control unit.