- Honda Tiller Owner's Manual

TILLING DEPTH ADJUSTMENT

To adjust the tilling depth, loosen the locking bolt and move the drag bar up

or down.

Before adjusting the drag bar, place the tiller on firm, level ground and stop the

engine.

Use the gauge lines and indentations on the drag bar to adjust the tilling depth.

Line up the top of the bar holder with a gauge line, and tighten the locking bolt.

The drag bar should always be used when tilling. It enables you to compensate

for the hardness of the soil. The ideal height of the drag bar will depend on the

type of soil and soil conditions at the time of tilling.

If breaking ground for the first time, lower the drag bar. As the soil becomes

softer, the drag bar can be raised. If not sure about soil conditions, start with

the drag bar in the lowest position.

If the machine jerks forward while tilling, press down on the handlebars.

This will cause the drag bar to dig more deeply into the soil.

INDENTATION

GAUGE LINE

IAG BAR

DRAG BAR

HOLDER

LOCKING BOLT