- Honda Tiller Owner's Manual

DRIVE BELT ADJUSTMENT

The drive belt must be inspected regularly for correct tension. If the drive belt

slips on its pulleys, that will result in loss of power and premature wear or

damage to the drive belt.

Inspection

1. Adjust the clutch cable (refer to page 45).

2. Remove the belt cover.

3. Stop the engine, remove the spark plug cap, and set the clutch lever in the

LOCK position. Pinch the upper and lower parts of the belt together with

both hands 5 or 6 times as shown in the figure, and check to see if the belt

gap and stopper gap are within the prescribed dimensions.

Belt gap: 42 - 45 mm (1.65 - 1.77 in)

Specified belt: FR650 V-belt red

-SII (SB38)

FR750 V-belt W600 (SB38)

4. Adjust if the gap is not within the prescribed dimensions.

BELT GAP: 42 - 45 mm

(1.65 - 1.77 in)

BELT TENSldN