Owner manual

10 of 17 AII 36587 (0705) © 2007 American Honda Motor Co., Inc. - All Rights Reserved.
33. Install one blind nut into each 8 mm hole.
34. Remove the four screws from the rear camera.
Route the rear camera harness through the rear
camera subbracket, and install the rear camera
subbracket to the rear camera with the four
screws.
35. Attach a piece of wire to the terminals from the
rear camera harness, and tape the wire to the
terminals.
32. Drill three 8 mm holes and one 10 mm hole in the
tailgate.
• Wrap tape around a 3 mm drill bit, and 8 mm
drill bit and a 10 mm drill bit 10 to 15 mm from
the end or use a drill stop.
• While wearing eye protection, drill a 3 mm
hole, then an 8 mm hole in all four locations.
Drill a 10 mm hole only in the upper center
hole.
• Remove any burrs, and apply touch-up paint
to all of the holes.
4708021
K
DRILL
DRILL BIT
(3 mm 8 mm)
TAILGATE
4 MARKS
TAPE
(Wrap tape around
the drill bit.)
DRILL BIT
10 ~ 15 mm
UPPER
CENTER
HOLE
DRILL BIT
(3 mm 8 mm
10 mm)
4708050
K
REAR
CAMERA
REAR CAMERA
SUBBRACKET
REAR CAMERA
HARNESS
4 SCREWS
4708030
K
TAILGATE
3 8 mm
HOLES
BLIND
NUTS
4913020
K
TERMINALS
TAPE
WIRE
REAR CAMERA
HARNESS
www.collegehillshonda.com