Owner manual

© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 11 of 17
36. Route the rear camera harness through the 10 mm
hole in the tailgate, and seat the grommet into the
10 mm hole.
38. Align the two locating tabs on the rear camera
subbracket with the slots in the rear camera
bracket, and install two 4 x 6 mm washer-screws.
NOTE: Make sure the flat surface of the rear camera
subbracket is facing up: otherwise, the camera view
will be upside down.
37. Install the rear camera bracket to the three blind
nuts with three 4 x 12 mm washer-screws.
4708041
K
BLIND
NUT
4 x 12 mm
WASHER
SCREWS
TAILGATE PANEL
REAR CAMERA
BRACKET
4708081
K
4 x 6 mm
WASHER
SCREW
REAR CAMERA
SUBBRACKET
(Flat surface
facing up.)
REAR CAMERA
BRACKET
4 x 6 mm
WASHER
SCREW
2 SLOTS
2 LOCATING
TABS
4708071
K
REAR CAMERA
HARNESS
10 mm
HOLE
GROMMET
GROMMET
WIRE
VEHICLE PANEL
www.collegehillshonda.com