Owner manual

© 2007 American Honda Motor Co., Inc. - All Rights Reserved. AII 36587 (0705) 13 of 17
42. Secure the rear camera harness to the harness
clamp bracket B with three small wire ties. Attach
the wire tie over the tape attached to the
harness.
45. Pull the rear camera harness out from the inside
of the tailgate, and secure the rear camera
harness to the harness clamp bracket A with one
small wire tie.
43. Torque the T50 TORX bolt to 29 to 32 N·m (21 to
23 lbs).
44. Close the tailgate. Remove the lower outboard
hinge bolt, and attach harness clamp bracket A to
the tailgate hinge with the TORX bolt you just
removed. Do not tighten the TORX bolt at this
time.
46. Torque the T50 TORX bolt to 29 to 32 N·m (21 to
23 lbs).
47. Using isopropyl alcohol on a shop towel, clean the
tailgate where the cushion tapes will attach. Using
scissors, cut one cushion tape in half. Secure the
rear camera harness to the tailgate with two half
cushion tapes and two full cushion tapes at the
locations shown.
5D10020
T
100 mm
25 mm
TAPE
SMALL
WIRE TIE
REAR
CAMERA
HARNESS
HARNESS
CLAMP
BRACKET B
T50 TORX BOLT
(Torque to 29 to32 N·m)
SMALL
WIRE TIE
(Attach over
the tape.)
5D10030
T
TAIL GATE
TAIL GATE
HINGE
HARNESS
CLAMP
BRACKET A
T50 TORX BOLT
(Do not tighten at this time.)
5D10041
T
TAIL
GATE
REAR
CAMERA
HARNESS
SMALL
WIRE TIE
HARNESS
CLAMP
BRACKET A
T50 TORX
BOLT
(Torque to
29 to32 N·m)
130 mm
4N09050
K
CUSHION TAPE
REAR CAMERA
HARNESS
REAR
CUSHION TAPE
(Cut in half.)
TAILGATE
www.collegehillshonda.com