Operation Manual

43 lbf·ft (59 N·m , 6.0 kgf·m)
16 lbf·ft (22 N·m , 2.2 kgf·m)
155
If You Have a Flat Tire
Taking Care of the Unexpected
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capability.
Used cotter pins may not effectively
secure fasteners. Always replace used
cotter pins with new ones.
After installing the wheel, apply the
brake several times. Check for free
wheel rotation after the brake is
released. Recheck the wheel if the brake
drags or the wheel does not rotate freely.
Installation
Adjust the drive chain (page ) and
rear brake pedal free play (page ).
Connect the brake rod to the brake arm.
Reassemble the brake stopper arm.
Tighten the stopper arm nut to the
specified torque:
Install the side collars.
Place the wheel into the swingarm and
install the drive chain over the rear
sprocket.
Insert the rear axle shaft from the right
side, through the right swingarm, brake
panel, wheel hub.
Tighten the rear axle nut to the
specified torque:
3.
4.
2.
5.
1.
115
101
6.
7.
8.
03/08/21 10:20:50 31KPJ630_164