Owner's Manual

9. TROUBLESHOOTING

When the engine will not start;

1. Is there enough fuel?

2. Is the fuel valve on?

3. Is the engine switch ON?

4. Is gasoline reaching the carburetor?

To check, loosen the drain screw with the fuel valve on. Fuel should

flow out freely. Retighten drain screw.

If any fuel is spilled, make sure the area is dry before testing

the spark plug or starting the engine. Fuel vapor or spilled fuel may ignite.

DRAIN SCREW

5. Is there a spark at the spark plug?

a. Remove the spark plug cap. Clean any dirt from around the spark

plug base, then remove the spark plug.

b. Install the spark plug in the plug cap.

c. Turn the engine switch on.

d. Grounding the side electrode to any engine ground, pull the recoil

starter to see if sparks jump across the gap.

e. If there is no spark, replace the plug.

If OK, try to start the engine according to the instructions.

6. If the engine still does not start, take the tiller to an authorized Honda

dealer.