Operation Manual

Line up the hole in the steering wheel hub with the hole in the shaft and insert the

pin supplied (3) using a hammer, ensuring that the end comes completely through

to the opposite side.

To avoid damaging the steering wheel, use a punch of the

same size as the pin when hammering it in the last part

3.3 FITTING THE SEAT

Raise the adjustment lever (3) and fit the

seat (1) in the slide (2), introducing it from

the steering wheel’s side, till the seat

engages in one of the 6 positions.

At this point the seat is engaged and can-

not be completely removed unless the

lever (4) is pressed, freeing it from its

retainer

3.4 CONNECTING THE BATTERY

The battery (1) is situated under the seat

and is held in place by a spring (2).

Connect the red cable (3) to the positive

terminal (+) and the black cable (4) to the

negative terminal (–) using the supplied

screws and following the illustrated

sequence.

NOTE

EN 10 UNPACKING AND ASSEMBLY

2 1 3