Operation Manual

adjustment, immediately contact your Dealer. DO NOT ATTEMPT OTHER

WORK ON THE BRAKE THAN DESCRIBED HERE.

6.3.5 A

DJUSTING THE TENSION OF THE DRIVE BELT

If you should notice that forward drive power

has dropped, it will be necessary to adjust the

tension of the spring of the stretcher to return

to former conditions.

Access for making this adjustment is by tak-

ing off the inspection hatch beneath the seat.

Loosen the locking nuts (2) and tighten or

loosen the screw (1) as much as necessary

for a length “A” of the spring (3) of:

A = 114 - 116 mm ( For mechanical drive models)

A = 109 - 111 mm ( For hydrostatic drive models)

measured to the outside of the end of the spring. When the adjustment has been

made, tighten the nuts (2).

When replacing the belt, take great care when using for the

first few times as engagement may be sudden until the belt is sufficiently run in.

6.3.6 A

DJUSTMENT OF THE SPRING OF THE PAWL FOR HOOKING THE GRASS-CATCHER

If the grass-catcher tends to jump about and to

open up when going over rough ground, or if it has

difficulty in hooking back on after being emptied,

the tension of the spring will need to be adjust-

ed(1).

Change the hooking point by using one of the holes

(2) until the required result is achieved.

NOTE

➤

EN 47MAINTENANCE