Operation Manual

6.4 DISMANTLING AND REPLACEMENT

6.4.1 R

EPLACING WHEELS

Stop the machine on a flat surface and put a block

under a load-bearing part of the frame on the side

that the wheel is to be changed.

The wheels are held by a snap ring (1) which can

be eased off with a screwdriver.

The rear wheels are directly coupled to the differen-

tial axle shaft and fastened by a key that forms part

of the wheel's hub.

Should you substitute one or both rear wheels, ensure that

they are of the same diameter, and check that cutting deck is horizontal to pre-

vent an uneven cut.

Before re-fitting a wheel, smear some waterproof grease on

the axle and carefully re-fit the snap ring (1) and washer (2).

6.4.2 R

EPLACING AND REPAIRING TYRES

The tyres are of the «Tubeless» type and therefore all puncture repairs will have

to be carried out by a tyre-repair expert in accordance with the methods for this

kind of tyre.

6.4.3 R

EPLACING BULBS

The bulbs (18W) have a bayonet fitting

and are installed in the bulb holder which

can be taken out by turning it anti-clock-

wise, using pliers.

IMPORTANT

NOTE

EN 48 MAINTENANCE