Product Manual

5
4. Tighten the four 5 x 28 mm bolt/washers.
TORQUE: 3.6 ft-lb (5 N·m)
5. Make sure the tie straps are positioned as shown.
6. Operate the throttle trigger and make sure the throttle operates
smoothly.
Kwik Loader™ Shield and Head Installation
Prior to installation, move the ignition switch to the STOP (O) position.
1. Install the cutting-line head debris shield as shown below.
2. Tighten the 5 x 28 mm bolt/washers:
TORQUE: 2.5 ft-lb (3.4 N·m)
3. Position cover plate/spacer A, spacer B, and washer on the shaft
as shown.
4. Insert the tip of a 4 mm hex wrench or equivalent fully into the gear
case hole and verify that the output shaft will not turn.
5. Position the Kwik-Loader trimmer head against the washer and
thread the collar onto the shaft making sure to seat the triangular
portion of the collar in the triangular opening in the trimmer head.
6. Grasp the trimmer head and tighten it by hand in the direction
shown.
7. Remove the 4 mm hex wrench from the gear case hole.
All output shafts use left-hand threads.
Brush/Wood (50-tooth) Shield and Head Installation
Prior to installation, move the ignition switch to the STOP (O) position
and disconnect the spark plug cap from the spark plug. Wear
protective gloves when working around the cutting-line head and saw
blade.
1. Install the brush/wood blade debris shield as shown below.
2. Tighten the 5 x 28 mm bolt/washers:
TORQUE: 2.5 ft-lb (3.4 N·m)
3. Insert a 4 mm hex wrench or equivalent into the gear case hole to
prevent the output shaft from turning.
7/8 in (100 mm)
7/16 in (60 mm)
CUTTING-LINE
DEBRIS SHIELD
(with cutoff knife)
5 x 28 mm
BOLT/WASHER (4)
SPACER (2)
[3/32 in (2.3 mm) thick]
CUTTING-LINE HEAD
SPACER B
COVER PLATE/
SPACER A
OUTPUT SHAFT
(left-hand thread)
4 mm HEX
WRENCH
GEAR CASE HOLE
WASHER
(used with Kwik
Loader head only)
COLLAR
(left-hand
thread)
TIGHTEN
BRUSH/WOOD BLADE
DEBRIS SHIELD
5 x 28 mm
BOLT/WASHER (4)
SPACER (2)
[3/32 in (2.3 mm) thick]