Instructions / Assembly

Assembly：

Please follow these instructions carefully to ensure safe and satisfactory use of this

product. Choose a location where the product is to be displayed. Take all the

components out of the carton for assembly. Ensure the product is placed on a flat,

level surface.

Step 1: Insert two angled tubes (Part A) into both ends of an arched tube (Part B).

And then tighten them with a screw (Part G) (screwdriver not provided) (See figure

1). Repeat this step to make 3 same parts.

Step 2: Insert a male cross brace (Part E-1) into a female cross brace (Part E-2),

and push into position. (See figure 2). Repeat to make other 6 set cross braces.

（Part E-1 set cross brace）

Step 3: Fix one assembled cross brace（Part E）on the top of 3 assembled

arched parts by 3 Sure-clips (Part F). 3 assembled arched parts should be

assembled at two sides of the cross brace and middle. (See figure 3)

Remark: When using a sure-clip, make sure the cross brace should always be on

the outside of the trellis and that the curved part of the sure-clips will always be

facing towards the inside of the trellis. (See figure 4)

Instructions of Sure-clips: Open the looped end of the Sure-clip and cross the cross

brace and the Arched parts and then around back to the cross brace. (See figure 5)

Note: This may take some extra strength as the Sure-clip is made to be tight.

The curved part of the

Sure-Clip will always be

facing towards the inside

of the Trellis.

Figure 2

Female Cross

Braces: E-2

Male Cross

Braces: E-1

Figure 1

cross braces

Sure-clips

Arch

Cross Support

Figure 4

Figure 5

06 07