Use and Care Manual

10
Thermostat controls
Display screen
Lo
Batt
Set
Cool
77
M32763
On
M32761
Heat Off Cool Auto On
Fan
Temperature
adjustment
Press the up or
down buttons
until you reach
the desired
temperature.
NOTE: Make sure
the SYSTEM switch
is set to the system
you want to control
(Heat or Cool).
Fan Switch is used to control your fan.
In “Auto” mode, the fan runs only when
the heating or cooling system is on.
If set to “On,” the fan runs continuously.
System Switch is
used to control your
heating or cooling
system.
• Heat: Heating
system control.
• Off: All systems
off.
• Cool: Cooling
system control.
Low battery warning
(see page 11)
Setpoint indicator
Appears when the setpoint
temperature is displayed.
Temperature
The ambient (measured)
temperature is normally
displayed. To view the
setpoint temperature,
press the Up or Down
button once. The
setpoint temperature will
appear for five seconds.
System status
Cool on: Cooling system is on.
Heat on: Heating system is on.
When Cool On is flashing, compressor
protection is engaged (see page 11).