User Manual

SECURE LOCKOUT PERIODS

If a wrong code is entered three times in a row, the digital keypad will begin a five-

minute secure lockout period. During this secure lockout period the keypad will

become disabled. Once the lockout period has expired, the safe can be unlocked

using the correct passcode. You may use the override key to open safe, but keypad

will complete the full lockout period.

OVERRIDE ACCESS KEY

If the pass code is unavailable or your keypad fails due to dead batteries or other

malfunction, you can open the safe using the override access key (see STEP 1. in the

SETUP section).

REPLACING BATTERIES

Note: The pass code will not be erased if the batteries become weak or are removed.

Weak or dead batteries should be replaced immediately and all 4 batteries should be

changed. To replace the batteries please follow the instructions in STEP 2. in the

“SETUP” section. Remember to always remove batteries from safe if not using for an

extended period of time. If your batteries are completely dead and you cannot open

the safe by using the digital keypad, use the override access key to open safe and

access the battery compartment.

NOTE: It is NOT RECOMMENDED to use Non-alkaline or rechargeable batteries.

IF YOU FORGET THE PASSCODE

1. Use the override access key to open safe.

2. With door open, press red reset button (C) inside

door.

3. Yellow light is on; enter new pass code in 30

seconds.

4. Enter pass code (3 to 8 digits) followed by “C”

5. Safe will beep and yellow light will turn off.