50190-03 Fan Manual

STANDARD OR ANGLE MOUNTING INSTRUCTIONS

9. Slide the downrod into the yoke of the motor

housing, align the holes, and reinstall the

downrod pin and downrod clip. Then retighten the

two set screws (Fig. 9).

10. Depending on the length of downrod you use,

you may need to cut the lead wires back to

simplify the wiring. If you decide to cut back

the lead wires, it is suggested that you do so in

the following manner: Take the lead wires and

make sure that you have pulled them all the way

through the top of the downrod and measure 8 in.

of lead wire, and then cut the excess wire off with

wire cutters (not included) (Fig. 10).

11. If you cut back the lead wire in Step 10, strip 1/2

in. of insulation from the end of each wire. Twist

the stripped ends of each strand of wire within

the insulation with pliers (not included) (Fig. 11).

Note: If you did not cut back the lead wires in Step

10, Step 11 is not necessary and you may

proceed to Step 12 instead.

Downrod

Set Screw

Downrod

Clip

Fig. 9

Fig. 10

Fig. 11

Cut Wires

Stripped

Wires

Downrod Pin

Downrod Clip