User manual

stances. It must be checked
by an authorized service
outlet.
lAs children do not
recognize the dangers that
can be created by electric
appliances, they must never
be left with the unit without
supervision.
lNever operate the unit or
pull the plug with wet hands.
lThe unit must only be
placed on a level, dry sur-
face that is insensitive to
water.
lCompare the data on the
rating plate with those of
your power supply- they must
be identical.
lAlways fill the unit with
fresh, cool tap water only.
lNever operate the unit with-
out water.
lDo not add aromas or addi-
tives to the water.
lNever operate the unit with-
out the decalcifying filter or
when the filter is used up.
Exchange the decalcifying fil-
ter after 5 months at the lat-
est.
lBefore cleaning, always
pull the power plug.
lDuring cleaning, take care
that no water enters inside
the unit. When you empty the
unit of the restwater, please
take care that the water does
not run into the hole of the
airflow which is on top of the
atomizing chamber . If
water goes into this
hole, the entire unit can be
damaged. Please empty the
water on the opposite side of
the airflow hole of the atom-
izing chamber. Never dip the
unit in water or put it in the
dishwashing machine.
lIf the machine has been put
out of operation for a longer
period of time, rinse the
water tank and the atomizing
chamber well before filling.
lIf the unit shows defects in
functioning, please do not
put it into operation any
more. It must be checked by
an authorized service outlet.
lRepairs must only be made
by authorized service outlets.
First Use
Before using the unit for the
first time, you should note the
following points:
lRemove all packing materi-
al from the unit (also the
sheeting from the decalcify-
ing filter).
lPlease check your water
hardness with the enclosed
test strips as described on
Page 10 of the operating
instructions.
Explanation of
Operation
Panel
1. Electronic Humidistat
for continuous adjustment of
the desired humidity. The
optimum value between 40%
and 60% is easy to adjust.
You press the button and
together
and
after some seconds on the
LCD display the current value
of humidity starts to flash.
Now it is possible to adjust
with the button or with
the button
the value of humidity you
want. After a few seconds
your chosen humidity value
disappears and the display
switches over to the current
humidity value of your room.
2. Water Level Indicator
If the red indicator lamp
is lit, this normally means that
water has to be refilled in the
tank or that there is too much
water in the atomizing cham-
ber and this must be
skimmed off.
Should the indicator lamp
stay on continuously despite
a correct water level, there is
a malfunction. In this case,
the unit must be brought to
the nearest service point.
3. Night Reduction
The humidifier is equipped
with an additional switch for
night operation. This lowers
the noise level by reducing the
fan speed and also reduces
the amount of humidity.
This is possible when you
press the button .On the
13
10
11
12
12
11
15
I3047.00 BH-860/861/862E OM.1 05/09/2006 14:19 Page 13