Owner's Manual

English: Page 1 • Français: Page 6 • Español: Página 11
3
Connect wires
1 Match each labeled wire
with same letter on terminal.
2 Use a screwdriver to loosen
screw terminals, insert bare
wires beneath screws, then
tighten screws.
3 Push any excess wire back
into the wall opening.
Labels don’t match?
If labels do not match letters on
thermostat, see table below.
Mount thermostat base
1 Drill holes at pencil-marked
locations (3/16” holes for
drywall, 7/32” holes for
plaster).
Existing wires Connect to:
R RH 4 V Terminal “R
W W1 H Terminal “W
2 Use hammer to tap anchors
into holes until flush with
wall.
3 Pull wires through thermo-
stat base and insert screws.
Check level if desired, then
tighten screws.