Full Product Manual

8 9
CARING FOR YOUR HUMIDIFIER (Continued)
1 gal. (3,8 l)
(1 c. à thé)
Step 1
$
$
Step 2
Follow steps 1-3 under Before Cleaning, then follow the additional steps below.
NOTE: Filter must be removed from humidifier during cleaning.
Do not clean Filter with bleach solution.
1. Mix 1 gallon (3.8L) of water with 1 teaspoon of bleach. Pour half of the bleach solution
into first Water Tank. Lift Tank and swish bleach solution around to wet entire inside of
Tank. Repeat for second Water Tank.
NOTE: Using more than 1 teaspoon of bleach to 1 gallon (3.8L) of water may result in
damage to the humidifier.
2. Place both Tanks on Base. Bleach solution will drain into Water Reservoir.
3. Allow bleach solution to remain in the Tanks and Base for 15-20 minutes.
4. Empty bleach solution from Tanks and Base. Rinse with clean water until the smell
of bleach is gone
TROUBLESHOOTING
Problem Possible Cause Solution
Power Knob is turned
to high (
) med ( ) or
low( ) and the Refill
light ( ) is off but the
unit is not running
Unit is not plugged in
No power at outlet
Set humidity level has been
reached ( ) (green light
is on)
Plug unit in
Check home circuits, fuses;
test outlet
Turn Humidity Control Knob to
a higher setting
Power Knob is turned to
high, med or low and the
Refill light ( ) is on
Water level may be low
Motor Housing not properly
seated on Base
Check water level and fill
if necessary
Set Motor Housing properly
on Base
Water leaking from Base Plunger Housing is damaged Contact Consumer Relations
for a new Tank
Plunger is sticking Push and release Plunger to
be sure it is moving freely
Tank is cracked
Float is not installed properly
Plunger Housing has
become loose
Inspect Tank for damage;
contact Consumer Relations
for a new Tank if necessary
Check to make sure Float
is snapped properly in place
and moves freely
Tighten Plunger Housing by
turning clockwise (to right)
Tank and Base are slimy Need to clean See “Caring for
your Humidifier”
Fan is running but water
level is not going down
Filter is clogged with
mineral deposits
See instructions for
“Caring for your Filter”;
purchase a new Honeywell
Replacement Filter
Water is not draining
into reservoir
Plunger may be stuck Push and release Plunger to
be sure it is moving freely
Tank Cover snapped off Used as a handle to carry full
Water Tank
Snap Tank Cover
back in place
MINUTES
Step 3 Step 4
Disinfecting
End of Season Cleaning
Follow cleaning instructions above when the humidifier will not be used for at least one week,
or it is the end of the season. Remove any accessories, including the Wicking Filter, and allow
the humidifier to dry completely before storing.
Do not store humidifier with water inside the Base, Water Reservoir or Water Tanks.
At end of season, remove and throw away filter. Do not store humidifier with a used
Wicking Filter.
PC-1, PC-2
or PC-1C
NOTE: Consider using a Protec
®
Cleaning Cartridge to keep your
humidifier cleaner longer. It will continuously clean and protect
against bacteria and mold. It will also help prevent the buildup of
slime in the water and on humidifier surfaces. The Protec Cartridge
will keep your humidifier cleaner longer between cleanings. However,
your humidifier still needs to be cleaned regularly.