Use and Care Manual

INSTALLATION
INSTALLATIONSAFETY INFORMATION PRE-INSTALLATION
IMPORTANT: Read all safety precautions and installations carefully before installing
or servicing this fixture.
• Do not handle any energized fixture or attempt to energize any fixture with wet
hands or while standing on a wet or damp surface or in water.
• Assure that the fixture is mounted onto a structurally sound surface that will
support the fixture.
• The fixture is designed for use in a 120 VAC, 60Hz fused circuit. Do not use on a
dimming circuit.
• Do not look into the lights.
• Product is intended for use in garages, basements, work areas, utility rooms and
recreation rooms.
• Maximum distance to the receptacle is determined by the length of the cord
provided.
(5 ft, 3-prong, 120V grounded plug included)
• Includes a protective sleeve, such as 0.010-inch (0.25-mm) thick fiberglass, where
the path of cord travel to the ceiling-mounted receptacle is not between the two
supporting chains.
• The fixture is intended to be installed directly beneath a ceiling-mounted recepta-
cle. Excess cord should be secured to one of the supporting chains with a cable tie
to keep it out of the work space.
• Use hook to support chain, not the electrical cord.
• Do not install on radiant-heating type ceiling.
• Maximum distance to the receptacle is determined by the length of cord provided.
WARNING: Failure to comply with these instructions could result in a potentially fatal
electric shock and/or property damage.
• Carefully remove the fixture from the carton and check to make sure that all
hardware is included.
• Be careful not to misplace any of the hardware needed for installing the fixture. If all
hardware is not included, call customer service number.
PLANNING INSTALLATION
HARDWARE INCLUDED
NOTE: The unit is intended to be installed directly beneath a ceiling-mounted receptacle.
If there is excess cord, bind with string or a cable tie to keep it out of work space.
ATTACH THE CEILING HOOKS
Choose desired location of light fixture making sure it is within reach of an outlet. Use a
pencil to place a mark on the ceiling where each ceiling hook (Part CC) should go. Screw
hooks in place until secure.
ATTACH THE “S” HOOKS
Insert the “S” hooks (Part BB) into each of the holes on both sides of the shop Light.
(Figure 1)
ATTACH THE HANGING CHAIN
1. Using two hanging chains (Part AA) attach a hanging chain to one of the “S”
hooks (Part BB) previously attached to each side of the light fixture. (Figure 2)
NOTE: The hanging chain must be bent in half in order to attach each side to an
“S” hook.
2. Attach two additional “S hooks” (Part BB) to the center of each hanging chain
previously attached.
3. Attach the remaining hanging chains (Part AA) to the “S” hooks (Part BB)
previously attached.
4. Adjust chain manually to achieve desired height.
5. Attach the remaining “S” hooks (Part BB) to the hanging chains and attach to the
ceiling hooks.
6. Plug power cord into an outlet to use pull chain to power on.
AA: 12 in. Hanging Chain (4)
Maximum Weight: 7 kgs.
BB: “S” Hook (8)
2.0 mm x 32 mm x 16 mm
CC: Ceiling Hook (2)
3.0 mm x 55 mm x 20 mm
~6 Ft.