Manualshelf

Christmas Tree Manual

ManualsBrandsHoneywell ManualsChristmas Trees6.5 ft. Whistler Fir Pre-Lit Artificial Christmas Tree with 400 Warm White LED Lights
12345678
TROUBLESHOOTHING
Loose branches
Fig. A
USER SERVICING INSTRUCTIONS
CAUTION! ALWAYS UNPLUG YOUR TREE FROM ITS POWER
SOURCE BEFORE ATTEMPTING EITHER FUSE OR LAMP REPLACEMENT.
EN 5
3. If you are still experiencing problems with the tree, please contact us at 866-205-9854.
If any lights do not work on your pre-lit tree, please check the following before
1. If entire tree or a section of the tree does not light:
a) Make sure the end connector of the power cord is well connected to the
c) Check that there is power at the electrical outlet.
d) Check fuses in tree’s plugs and replace if necessary (see Replace the fuse below).
2. If a strand of lights still does not work:
a)
b)
b) Check that each section of the tree is well connected.
calling customer service:
bottom section (C).
Check that all lamps are tightly fitted inside the lampholders and that no lamps
are broken or missing. Replace any broken or missing lamps with replacement
lamps provided (see Replace the lamp below). If all lamps are firmly in the lam-
pholders, sli
ghtly twist the lamps from side to side to ensure proper connection.
If the lights still do not work, carefully remove each lamp one by one out of the
problem light string. Pull the lamp AND plastic base straight out of lampholder.
Do not twist lamps while removing from lampholders. Check two wires at the
bottom of the lampholder. Each wire should be aligned properly on the lamphold-
er to ensure a proper connection in the lampholder. If one wire is missing or too
short, please replace la
mp with a replacement lamp (provide).
If a branch of the tree falls off, follow the steps below to reinstall it with a spare bolt.
1.
2.
Place the branch into the slot of the bracket.
Insert a spare bolt through the hole and use diagonal
pliers (not included) to crimp the bolt. (See Fif.A)
Replace the fuse:
A)
1. Grasp plug and remove from the receptacle or other outlet device. Do not
unplug by pulling on cord.
Replace the fuse of extension cord with foot pedal switch (1 replaceable 5 A, 125 V
fuse is located in the plug):
Note: This plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug.
2. Open fuse cover. Slide open fuse access cover on top of attachment plug
towards blades.