Operation Manual

20
3.1 DETERGENT DISPENSER (Optional)
(Fig. 8)
The machine is equipped with an automatic detergent
dispenser.
• Insert the red supply tube (16) into the canister (17).
ATTENTION
Always wash the hands under running water if they come
into contact with detergent, or comply with the specific
indications pertaining to the utilized type of detergent
itself.
• Proceed with a few no-load cycles until the intake and
delivery tubes have filled.
To adjust the dispenser, refer to the relative enclosed
manual and to the utilized type of detergent.
3.2 FILLING THE RINSING AGENT
DISPENSER (Fig. 8)
• Insert the transparent tube (18) into the canister (19)
containing rinsing agent.
• Start the machine as described in paragraph 3.3. The
dispenser will suck about 3 cm of liquid from the
canister.
• Fill during the cycle by opening (slightly) and closing
the door until the tube has completely filled.
3.2.a Adjusting the dose (Fig. 8)
• Start the machine as described in paragraph 3.3 and
hold a glass up to the light at the end of the cycle.
• The drops of water on the glass will indicate insufficient
dosage while streaks will indicate that dosage is
excessive either in relation to density or quantity.
• Regulate by means of the plug (20), turning clockwise
to decrease the quantity or anticlockwise to increase it.
IMPORTANT
These data are indicative and not binding since they may
vary according to the hardness of the water or the utilized
type of detergent and rinsing agent.
ATTENTION
If the utilized product (detergent or rinsing agent) is
changed, it is advisable to flush out the dosing system with
water and to then proceed by filling the dispensers.
3.3 PREPARING THE MACHINE AND THE
WASHING OPERATIONS
3.3.a Preparing the machine (Fig. 9)
1. Turn on the main power switch prior to the machine.
2. Turn on the cold water cock.
3. Make sure that the canisters of detergent (Optional)
and rinsing agent contain sufficient product for daily
needs.
Part 3:
For the operator
ENGLISH