Operation Manual
2
*Certain Models Only **Nozzle design may vary according to models
GETTING TO KNOW YOUR CLEANER
A. Accessory Door*
C. Main Cleaner
E. Accessory Door Latch
F. On/Off Pedal
H. Variable Power Control Slider
K. Hose Handle
L. Suction Regulator
M. Hose
N. Telescopic Tube Adjuster
O1. Telescopic Tube*
O2. Telescopic Tube (without Latch Fit)*
P1. Carpet and Floor nozzle**
P2.
Carpet and Floor nozzle (without Latch Fit)**
Q. Floor type selector*
S. Pre-motor Filter
T. Exhaust Filter
V. Accessories:
V1. Crevice Tool*
W. Pet Hair Remover Mini Turbo Nozzle*
X. Allergy Remover Mini Turbo Nozzle*
Latch Fit)*
GETTING TO KNOW YOUR CLEANER
Remove all components from the packaging.
1. Connect the hose to the cleaner main body. To release the hose: Simply press the
two latches on the hose end and pull. [1]
2. Connect the hose handle to the tube upper end.
[2]
[3]
USING YOUR CLEANER
1. Extract power cord and plug it into the power supply. Do not pull the cord beyond
the red m
ark
er.
[4]
2. Adjust the telescopic tube to the desired height by moving the telescopic tube adjuster
and raise or lower the tube to the most comfortable cleaning position.
[5]
* on the nozzle [6] to select the
Hard Floor
Carpet
4. Switch the cleaner on by pressing the On/Off pedal on the cleaner main body. [7]
5. Slide Variable power control to increase or decrease the power.
[8]
6. Adjust the suction regulator to the desired level.
[9]
7. Switch off at the end of use by pressing the on/off Pedal. Unplug and press the cord
reel pedal to wind the power cord back into the cleaner.
[10]
PARKING AND STORAGE SECTION
1. The tube can be parked on back or on the bottom of the cleaner for storage or
temporary storage while in use. [11]
2*. Th
e hose, tube and nozzle can be in “Nano Pack” storage position when not in use
:
[12]
A. Retract the telescopic tube to its storage length.
C. Remove the hose handle from the telescopic tube.
the product.
E. Park the hose handle on the product through the handle holder.
F. Assemble the nozzle into the parking slot underneath the product.
Assemble the telescopic tube into the remaining parking slot underneath the product.
CLEANER MAINTENANCE
Replacing the Dust Bag
If the bag check indicator is red please check and, if necessary, replace the bag.
1. Lift the bag door Latch to open the bag door, close the bag to avoid dust escaping
by pulling the tongue and remove the bag [13]. The full dust bag should be disposed
of correctly and carefully.
2.
holder. [14]
REMEMBER: The bag check indicator may be red if an obstruction has occurred. In this
Cleaning the Filter:
Cleaning the pre-motor lter:
1. Lift the bag door latch to open the bag door.
2. [15]
[15]
4. Wash it in hand warm water [16], and allow it to dry [17] thoroughly before replacing
to the cleaner [18].