Operation Manual
3
*Certain Models Only **Nozzle design may vary according to models
USER CHECK LIST
Should you have a problem with the product, complete this simple user checklist before
calling your local HOOVER service.
Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
Has the cleaner overheated? If so, it will take approximately 45 minutes for the cut
out to automatically reset.
IMPORTANT INFORMATION
HOOVER spares and Consumables
Always replace parts with genuine HOOVER spares. These are available from your local
Consumables
HEPA
Filter kit (pre-motor and exhaust):
Spares (with Latch Fit)
Carpet and Floor Nozzle:
Complete Flexible Hose:
Spares (without Latch Fit)
Quality
Your Guarantee
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice.
Cleaning the exhaust lter:
1. 19]
2. [16] and allow it to dry
[1
7] thoroughly before
20
]
REMEMBER: Do not use hot water or detergents. In the unlikely event of the
Cleaning the permanent cloth dust bag* (certain models only)
To maintain optimum performance we recommend that you wash the permanent cloth
dust bag under hand warm water after every 5 full bags. Remove excess water and leave
to dry fully before replacing.
Removing a blockage from the system
If the bag check indicator is red:
2. If it is not full, then;
A.
remove any blockage from
WARNING*: - The bag check indicator will remain red if the cleaner is used when the bag is
the bag check indicator red,an electronic cut out will switch the cleaner off to prevent any risk
of overheating. If this should happen,switch the cleaner off,unplug and correct the fault(see
ACCESSORIES AND NOZZLES
The crevice tool*, furniture nozzle* and dusting brush* are stored on board under the
[21]
Crevice Tool* – For corners and hard to reach areas. [V1]
Dusting Brush* – For bookshelves, frames, keyboards and other delicate areas. [V2]
Furniture Nozzle* – For soft furnishings and fabrics. [V3]
Hard Floor Nozzle[Z1, Z2]
Pet Hair Remover Mini Turbo Nozzle*– Use the mini turbo nozzle on stairs or for
deep cleaning on textile surfaces and other hard to clean areas. [W]
Allergen Remover Mini Turbo Nozzle
* – Use the mini turbo nozzle on stairs or for
deep cleaning on textile surfaces and other hard to clean areas. [X]
Grand Turbo Nozzle*
–
Use the turbo nozzle for deep cleaning on carpets.
[Y]
IMPORTANT: Do not use the grand turbo nozzle or mini turbo nozzles on rugs with long
fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary
while the brush is rotating.