Installation Guide

INSTALLATION STEPS

Page 1

INSTALLATION GUIDE

INSTALLATION STEPS

STEP TWO

STEP ONE

Built-in washing machine

Place the corrugated plastic sheet, found on top of the

appliance during the unpacking process, into the base

of the appliance as shown in (fig 2)

(according to the model, consider A,B,C).

Cover the open transportation screw holes with the

2 or 4 plastic clips including the instruction bag.

Release the power cable and drain hose from

the securing clip at the rear of the machine.

Remove the 2 or 4 transit screws (A)

on the back and remove the 2 or 4 flat washers,

rubber bungs & plastic spacer tubes (B)

as illustrated in (fig 1).

If the washing maching is built-in unscrew the 3 or 4

transit screws (A) on the back and remove the 3 or 4

flat washers, rubber bungs and plastic spacer tubes (B).

During the removal of the screws occasionally spacer

tubes can fall inside the product, these can be removed

by tilting the product forward & recovering them from the

floor or inside the base of the machine.

PAGE 1
INSTALLATION GUIDE Built-in washing machine INSTALLATION STEPS INSTALLATION STEPS STEP ONE Release the power cable and drain hose from the securing clip at the rear of the machine. Remove the 2 or 4 transit screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs & plastic spacer tubes (B) as illustrated in (fig 1). STEP TWO If the washing maching is built-in unscrew the 3 or 4 transit screws (A) on the back and remove the 3 or 4 flat washers, rubber bungs and plastic spacer tubes (B).
PAGE 2
INSTALLATION GUIDE Built-in washing machine INSTRUCTIONS FOR MOUNTING THE FURNITURE DOOR STEP ONE Position the template onto the reverse of the door. The hinges & closure magnet can be fitted on the right or left hand side depending on your requirements. Mark the screw holes positions, then drill out these positions. STEP TWO Mount the furniture door to the front of the washer using the hinges. Place the spacers under the hinges (I) & then fix in position with screw (H).
PAGE 3
INSTALLATION GUIDE Built-in washing machine PLUMBING CONNECTIONS SETTING STEP ONE STEP ONE Connect the water hose to the water supply tap (fig 3) only using the hose supplied with the appliance (Do not reuse old hose-sets) The washing machine should be installed in its final position making sure the water fill hose is not kinked or trapped. The corrugated drain hose should be inserted into suitable drain pipe of between 50cm & 85cm height above the floor using the curved drain hose support.