Installation Guide

INSTALLATION GUIDE
Built-in washing machine
INSTRUCTIONS FOR MOUNTING
THE FURNITURE DOOR
Page 2
STEP TWO
STEP ONE
The 4 adjustablefeet allow the height of the washer to
be adjusted from 820mm to a maximum height of
840mm. To adjust the height, you should remove the
nuts fitted to each foot and replace these with the 5mm
nuts supplied. Raise the feet to your desired height and
then fully tighten the lock nut to the base of the washer.
Slide the washer into an opening the size indicated in
the diagram opposite. A furniture plinth may run across
the front of the appliance, but its height will be dictat-
ed by the height the washer is set at.
We suggest mounting the furniture door so that it opens
towards the left, which is the smae direction as the
porthole door. This will leave more space when you are
loading the washing into the appliance.
Mount the furniture door to the front of the washer
using the hinges. Place the spacers under the hinges (I) &
then fix in position with screw (H).
Snap mount cap (G
) in the lower position.
Mount the plate (D) on the right or left hand side,
depending on your installation requirements. Place the
plastic support (E) under the plate & fix it in position with
screw (F).
Fix the hinges in place with the 4 screws provided (A).
Position the template onto the reverse of the door. The
hinges & closure magnet can be fitted on the right or left
hand side depending on your requirements. Mark the
screw holes positions, then drill out these positions.
Fix the magnet (B) in place using screw (C).