Use and Care Manual

PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION

Cleaner won’t run 1. Not firmly plugged in 1. Plug unit in firmly

2. No voltage in wall plug 2. Check fuse or breaker in home

3. Blown fuse or tripped breaker 3. Replace fuse or reset breaker in home

4. Fuse in cleaner blown 4. Take to service center

Low suction 1. Dirty Water Tank full⁄automatic shut

off engaged

1. Remove and empty Dirty Water Tank.

See "How to Empty" page 12

2. Dirty Water Cap or Plug not on

correctly

2. Tighten

3. Dirty Water Tank Debris Filter Clogged 3. See "How to Clean" page 12

4. Blockage in nozzle 4. See "How to Clean" page 13

5. Recovery Tank not properly secured 5. Replace Recovery Tank and secure

recovery tank latch

6. Clogged Filter 6. Clean it

Clean water won't

dispense

1. Clean Water Tank not firmly in place 1. Make sure tank is securely locked in

position

2. Clean Water Tank or solution

container empty

2. Refill container according to cleaning

instructions

3. Ensure trigger is being pulled

Brushes won't

rotate during floor

cleaning

Check for jams and⁄or broken belt