User's Manual
Table Of Contents
- SAFETY INFORMATION
- COMBI REFRIGERATOR HOOVER
- TRANSPORTATION INSTRUCTIONS
- INSTALLATION INSTRUCTIONS
- STARTING TO USE
- COMBI OPERATION
- Appliance connected to power at the first time: When the appliance is connected to power at the first time, the display will be lit for 2 seconds before going normal and the appliance runs with intelligence function. Display Control: When the refriger...
- VERTICAL DISPLAY (if present)
- TOP FEAUTRED VERTICAL DISPLAY (if present)
- SETTING Button: Press “SETTING” to change the temperature. When button is pressed for the first time: You can change refrigerator temperature with ▲ PLUS Button and ▼ MINUS Button.
- When button is pressed for the second time: You can change refrigerator temperature with ▲ PLUS Button and ▼ MINUS Button.
- ON/OFF Button: To turn on Refrigerator Press ON/OFF button for 3 seconds. To turn off Refrigerator: Press ON/Off button for 3 seconds.
- Stand-by Mode: To save energy is possible to activate Stanby Mode. The refrigerator will work in normal state and all leds will turn OFF To enter Stan-by Mode: Press ON/OFF button for 1 second. To deactivate Stan-by Mode: Press ON/OFF button for 1 sec...
- HOLIDAY Button: In case of long stops, the Holiday function can be used. This function deactivates the fridge compartment, while leaving the freezer on. Ensure that there is no food inside the fridge compartment before using this function. The functio...
- INTERNAL USER INTERFACE (if present)
- TECHNICAL FEATURES
- ENERGY SAVING
- TAKE CARE
- CHANGING THE INTERNAL LIGHT
- REVERSING THE DOOR SWING
- TROUBLE SHOOTING
TAKE CARE
Defrosting
This appliance has automatic defrosting system, no need to defrost by hand.
Cleaning and Care
After defrosting you should clean the Fridge/Freezer internally with a weak solution of bicarbonate
of soda. Then rinse with warm water using a damp sponge or cloth and wipe dry. Wash the baskets
in warm soapy water and ensure they are completely dry before replacing in the Fridge/Freezer.
Condensation will form on the back wall of the Fridge; however it will normally run down the back
wall and into the drain hole behind the salad bin.
The drain hole will have a “cleaning spike” inserted into it. This ensures that small pieces off food
can not enter the drain. After you have cleaned the inside of your Fridge and removed any food
residues from around the whole, use the “cleaning spike” to make sure that there are no blockages.
Use standard furniture polish to clean the Fridge/Freezer exterior. Make sure that the doors are
closed to prevent polish getting on the magnetic door seal or inside.
The grille of the condenser at the back of the Fridge/Freezer and the adjacent components can be
vacuumed using a soft brush attachment.
Do not use harsh cleaners, scouring pads or solvents to clean any part of the Fridge/Freezer.
CHANGING THE INTERNAL LIGHT
1. Before carrying out the LED replacement always disconnect the mains supply.
2. Hold and lift up the LED light cover.
3. Remove the old LED by unscrewing it in an anti-clockwise direction.
4. Replace with a new LED light by screwing it in a clockwise direction marking sure that it is
secure in the light holder.
5. Refit the light cover and re-connect your Fridge to the mains supply and switch on.