User's Manual
Table Of Contents
- SAFETY INFORMATION
- COMBI REFRIGERATOR HOOVER
- TRANSPORTATION INSTRUCTIONS
- INSTALLATION INSTRUCTIONS
- STARTING TO USE
- COMBI OPERATION
- Appliance connected to power at the first time: When the appliance is connected to power at the first time, the display will be lit for 2 seconds before going normal and the appliance runs with intelligence function. Display Control: When the refriger...
- VERTICAL DISPLAY (if present)
- TOP FEAUTRED VERTICAL DISPLAY (if present)
- SETTING Button: Press “SETTING” to change the temperature. When button is pressed for the first time: You can change refrigerator temperature with ▲ PLUS Button and ▼ MINUS Button.
- When button is pressed for the second time: You can change refrigerator temperature with ▲ PLUS Button and ▼ MINUS Button.
- ON/OFF Button: To turn on Refrigerator Press ON/OFF button for 3 seconds. To turn off Refrigerator: Press ON/Off button for 3 seconds.
- Stand-by Mode: To save energy is possible to activate Stanby Mode. The refrigerator will work in normal state and all leds will turn OFF To enter Stan-by Mode: Press ON/OFF button for 1 second. To deactivate Stan-by Mode: Press ON/OFF button for 1 sec...
- HOLIDAY Button: In case of long stops, the Holiday function can be used. This function deactivates the fridge compartment, while leaving the freezer on. Ensure that there is no food inside the fridge compartment before using this function. The functio...
- INTERNAL USER INTERFACE (if present)
- TECHNICAL FEATURES
- ENERGY SAVING
- TAKE CARE
- CHANGING THE INTERNAL LIGHT
- REVERSING THE DOOR SWING
- TROUBLE SHOOTING
REVERSING THE DOOR SWING
Dissemble the Refrigerator Door
1. a.Use a tool to remove the screw off the hinge cover, and then
remove the latter. Insert the communication line to the hole on
the cabinet top.
b. Use a tool to remove the 4 screws off the upper hinge
cover and then remove the latter.
Pry up the door bush and small end cap cover on the door.
c. Insert the door bush and door communication line into the
hole on the door and then put on the small end cap cover.
d. Use a tool to remove the 2 screws as shows in the
below figure to remove the hole cover on the cabinet top
and get the cabinet communication line out of the hole.
Pry up the small end cap cover on the door and get out the
door bush and door communication line.
e. Insert the door bush into the round hole on the door and then
put on the small end cap cover.
f. Move the refrigerator door upward over 500mm to remove
the door.