User's Manual
Table Of Contents
- SAFETY INFORMATION
- COMBI REFRIGERATOR HOOVER
- TRANSPORTATION INSTRUCTIONS
- INSTALLATION INSTRUCTIONS
- STARTING TO USE
- COMBI OPERATION
- Appliance connected to power at the first time: When the appliance is connected to power at the first time, the display will be lit for 2 seconds before going normal and the appliance runs with intelligence function. Display Control: When the refriger...
- VERTICAL DISPLAY (if present)
- TOP FEAUTRED VERTICAL DISPLAY (if present)
- SETTING Button: Press “SETTING” to change the temperature. When button is pressed for the first time: You can change refrigerator temperature with ▲ PLUS Button and ▼ MINUS Button.
- When button is pressed for the second time: You can change refrigerator temperature with ▲ PLUS Button and ▼ MINUS Button.
- ON/OFF Button: To turn on Refrigerator Press ON/OFF button for 3 seconds. To turn off Refrigerator: Press ON/Off button for 3 seconds.
- Stand-by Mode: To save energy is possible to activate Stanby Mode. The refrigerator will work in normal state and all leds will turn OFF To enter Stan-by Mode: Press ON/OFF button for 1 second. To deactivate Stan-by Mode: Press ON/OFF button for 1 sec...
- HOLIDAY Button: In case of long stops, the Holiday function can be used. This function deactivates the fridge compartment, while leaving the freezer on. Ensure that there is no food inside the fridge compartment before using this function. The functio...
- INTERNAL USER INTERFACE (if present)
- TECHNICAL FEATURES
- ENERGY SAVING
- TAKE CARE
- CHANGING THE INTERNAL LIGHT
- REVERSING THE DOOR SWING
- TROUBLE SHOOTING
2. a. Use a tool to remove the 3 screws off the middle hinge cover
and then remove the middle hinge.
b. move the freezer door upward over 500mm to remove the door.
c. Remove the adjustable front feet under the lower hinge; use a tool to remove the 4 screws
from the lower hinge and then disassemble the lower hinge. Door disassembly is finished.
The pictures are for illustrative purposes only.
Assemble door, lower hinge accessories to the corresponding positions
1. a. Use a tool to get the door bush out as shown in the below figure and assemble it to the
corresponding position of the other side.
b. Use a tool to remove the screws off the stopper ass as shown in the below figure and then
assemble them to the other side of the door.