User Manual


Placement
Start



The refrigerator is placed in a
well-ventilated indoor place;
the ground shall be flat, and
sturdy (rotate left or right to
adjust the wheel for leveling if
unstable).
The refrigerator shall stay
for half an hour before
connecting 220-240V/
50Hz power when it is
firstly started.
The refrigerator shall run
2 to 3 hours before loading
fresh or frozen foods; the
refrigerator shall run for
more than 4 hours in
summer in advance
considering that the
ambient temperature is
high.
Thermostat
Illu minatin g la mp and repla cement
The temperature selector knob is located on the right hand side wall of the refrigerator interior
SettingĀOffā˖UnitOff
SettingĀMinā˖Less Cool Temperature
SettingĀMedā˖Normal Operation(adequate for most situations)
SettingĀMaxā˖Coolest Temperature
For the first time you install your refrigerator, set the thermostat knob at ĀMedā
Give your refrigerator time to cool down completely before adding food. It is the best to wait
24 hours before adding food.The thermostat knob controls the temperature. When the
thermostat control knob is set to OFF, the refrigerator will not be running.
Before using the
refrigerator, remove all
packaging materials
including bottom
cushions and foam pads
and tapes inside the
refrigerator, tear off the
protective film on the door
and the refrigerator body.
Please leave enough space to
ensure feasible opening and
drawer removal.
Dimensions shown are for
reference only.
Keep away from heat and
avoid direct sunlight. Do not
place the freezer in moist or
watery places to prevent rust
or reduction of insulating
effect.
The top space of the refrigerator
shall be greater than 30cm, and
the distances from both sides and
backside shall be more than 10
cm to facilitate the opening and
closing and heat dissipation.
Wipe the refrigerator inside and
outside with warm moist rag (add
a small amount of detergent in the
warm water and wipe clean finally
with clean water).
915mm
549mm
951mm
580mm
If the refrigerator lamps damaged please contact our customer service
MIN
OFF
MED
MAX
When environment temperatures is high (e.g. on hot summer days), if the thermostat setting is Coolest
(positioning MAX), the compressor runs continuously.
Reason: when the ambient temperature is high, the compressor runs continuously to maintain the low
temperature in the appliance.
The freezing and storage test should be done, according to regulation, removing all drawers except the
bottom one.