GENERATION FUTURE PUREPOWER USER INSTRUCTIONS 48000164 - 3 Purepower UK IM.
IMPORTANT SAFETY REMINDERS User manual - This cleaner should only be used for its intended purpose as described in these instructions. Ensure that these are fully understood before operating this appliance. Only use attachments recommended or supplied by Hoover. When using cleaning tools, ensure that the cleaner is kept in the upright (parked) position. This will avoid possible damage to the carpet or floor covering. When cleaning stairs, DO NOT position the cleaner above you. STATIC ELECTRICITY.
GETTING TO KNOW YOUR CLEANER* purepower Effortless cleaning with your new Hoover Cord storage swivel hook Handle purepower Supply cord Cleaner body When first unpacking your cleaner please check all items are included: On/Off switch 48000164 - 3 Purepower UK IM.
CARPET CARE CONTROL SELECTOR PREPARING TO USE YOUR CLEANER The carpet care control selector raises or lowers the height of the nozzle. The nozzle height will not change until the handle is released. Try various settings until you get the best results for each of your carpets. 1 Insert handle into body of cleaner. Slide into position. Ensure handle is flush with body of cleaner. Tighten large screw (pre-fitted to handle upper hole). Insert small screw into handle lower hole and tighten.
CLEANING TOOLS* ! CHANGING THE DISPOSABLE BAG IMPORTANT: When using cleaning tools, the cleaner must be kept in the upright (parked) position, particularly when cleaning stairs. The carpet height selector should also be set to tool mode: Pet Hair & Allergen Remover * Ideal for removing pet hairs. Do not touch the rotating brush. Hard Floor Caresse Nozzle* Ideal for cleaning delicate surfaces. For use combine with the Rigid Extension tube.
! CLEANING THE FILTERS* IMPORTANT: For optimum cleaning performance, always keep your filters clean. Pre- motor filter Exhaust filter The pre-motor filter should be washed every three months. The exhaust filter should be washed every month. The Carbon filter is normally maintenance free, this component should not be washed. If a replacement is required please contact our spares department.
CHANGING BELT OR BRUSHES 1 2 3 IMPORTANT: Switch cleaner off and remove plug from electricity supply before checking the brushes or removing hood. If your cleaner is not picking up efficiently, the belt or brushes (or both) may need replacing, but first make sure you have: • Emptied the dust container • Cleaned filters • Checked for blockages B 1 4 A Remove hood • Prise off the carpet care control selector. • Remove hood screws A and B. • Lift off hood.
Quality Genuine HOOVER Spares Tel. 08443 712 758 www.hooverspares.com ISO 9001 Hoovers factories have been independently assessed for quality. Our products are made using a quality system which meets the requirements of ISO 9001. Always replace parts with genuine Hoover spares. When ordering parts always quote your model number.
User checklist WARNING! A thermal cut out switches off the cleaner to prevent overheating if it is used when full or there is a blockage or dirty filters. If this should happen switch off, unplug and correct the fault. It will take about 30 minutes for the cut out to automatically reset. If your cleaner is not working properly run through the following checklist. 1 Is there a working electricity supply to the cleaner? Check with another electrical product. 2.
48000164 - 3 Purepower UK IM.
GENERATION FUTURE Hoover Limited Pentrebach Merthyr Tydfil Mid Glamorgan CF48 4TU HOOVER CUSTOMER HELPLINE 08444 995 599 © 2010 48000164-3 48000164 - 3 Purepower UK IM.
