HOOVER_ FoldAway TM Upright Thank you for your purchase! Owner's ENGLISH www.hoover.com Manual -_ pp.
Review this manual before operating cleaner Thank Please enter The numbers you the for choosing COMPLETE are located model on the and bottom serial of your product, a HOOVER® numbers in the spaces provided. cleaner. Model Serial number Hint: Attach your sales receipt Verification of date of purchase of your HOOVER product. Be sure to fill out cleaner (see back and return cover). to this owner's manual.
If you need any assistance: Visit our website at www.hoover.com. Click on the "Service" button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) OR Call 1-330-499-9499 Response Center. to speak with a representative in our Consumer Please do not return this product to the store. Carton contents Your cleaner comes fully assembled with the tools and hose stored on board. Remove any tape or packing material from the cleaner. A.
Cleaner description r.M 1. FoldAway TM handle 2. Upper handle release button 3. Dirt cup handle/latch 4. Carrying handle 5. Dirt cup filter chamber 6. Pleated filter (inside filter chamber) 7. Dirt cup 8. Headlight 9. Stair cleaning handle: located under the headlight. 10. Hood 18----_ 10 11 15. Dusting brush 16. Extension wand 17. Crevice wand: stores inside wand 18. Cord hooks: wrap cord around hooks for storage. The top hook rotates to the left for easy cord release. 19.
Xx Transporting cleaner Carrying handle Put handle in upright position. Tilt cleaner back on rear wheels. Push forward. Use the carrying handle to lift the cleaner. Settings Cleaning flexible For maximum cleaning performance, the following carpet height settings are recommended. • Low setting: for all types of carpet and hard floors. Note: If the cleaner is difficult to push, rotate knob to the next higher setting.
Cleaning tools Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas. The cleaner is ready for tool use when handle is in upright position. CAUTION: Agitator continues to rotate while cleaner handle is in upright position. Avoid tipping cleaner or setting it on furniture, fringed area rugs or carpeted stairs during tool use. F -----% G ( )1 Select proper tool D.
Familiarize yourself withthesehome maintenance tasksasproperuseand careofyourcleaner willensure continuedcleaning effectiveness. When Dirt cup CAUTION: Very fine materials, such as face powder or cornstarch, may seal the filter and cause loss of suction. When using the cleaner for this type of dust, empty the cup and clean the filters often. W to empty It is recommended that the dirt cup be emptied before the dirt reaches the dirt opening on back of dirt cup (Fig. 4-2) or after every use if preferred.
W Although not necessary, the filter can be removed from the lid for cleaning. Replace lid and filter on filter chamber. Replace chamber on dirt cup. Place bottom of cup behind tab (H) and press cup into cleaner. Rotate dirt cup handle (E) up to lock cup in place. Pull filter off lid and tap bottom of filter. To replace, firmly press filter onto lid until it stops. Final filter Correct. Be certain that the dirt cup is locked in the correct position.
Belt replacement The belt on your Hoover cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the hood of the cleaner and should be checked from time to time to be sure it is in good condition. When to replace Disconnect cleaner from electrical outlet. To check belt, remove hood and agitator cover as shown in Figs. 3-17 through 319. Replace belt if it is stretched, cut or broken. What to buy How to replace Disconnect outlet.
Replace hood, 2 screws and hose. Replace agitator cover (M) and 2 screws. The When agitator brush roll to replace When agitator brushes are worn, the agitator should be replaced. To check condition of brushes, disconnect cleaner from electrical outlet. Move edge of a card across bottom plate while turning agitator. To maintain cleaning effectiveness, replace agitator if brushes do not touch card. What to buy When purchasing How to replace Disconnect cleaner Therma| from electrical outlet.
Service To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by: • checking the Yellow Pages under "Vacuum Cleaners - Household" OR • checking the list of Factory Service Centers provided with this cleaner OR• checking the Service section of The Hoover Company on-line at www.hoover.com OR • calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only).
Fu[! One Year Warranty (Domestic Use) Check airflow path 6. Remove hose end from cleaner. 7. Plug cleaner in and turn ON. Check for suction at end of hose (C). a. If there is suction, continue with step 8. b. If there is no suction, check for blockage in hose. Clear out hose. Check hose inlet 8. Turn cleaner OFF and unplug. 9. Remove hose end from cleaner. 10. Press hose inlet door open and clear any blockages.
