Manual

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
Ifappliance is not working as it should, has been dropped, damaged, leftoutdoors, or dropped into water, take
it to a service center prior to continuing use.
WARNINGA
To reduce risk of personal injury - Unplug vacuum before servicing.
PROBLEM
Vacuum won't
run
System Check
Indicator has
turned red
or
Vacuum won't
pick up
or
Low suction
Cord Rewind
does not work
Dust escaping
from vacuum
Headlight not
working
Vacuum is
difficult to push
or won't move
forward
Powered Hand
Tool brushroll
won't turn
Smoky/burning
smell detected
POSSIBLECAUSE POSSIBLESOLUTION
2. Blown fuse or tripped breaker. 2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
1.Rinsable Filter and/or Filter
made with HEPA media is dirty.
3. Broken or worn belt.
5. Carpet height setting is incorrect.
1. Clean Rinsable Filter and or Filter made
with HEPA media - Pg. 9 and 10.
3. Replace belt - Pg.12.
5. Set Carpet Height Adjustment to appropri-
ate setting for carpet being cleaned - Pg.7.
1. Dirt cup full. 1. Empty dirt cup - Pg. 9.
3. Hose not installed correctly. 3. Review Hose installation - Pg. 7.
6i:: : iire te _
E#:: a!; S:: !st j:j _a: J ete!;:::::::::::::::::::::. a: _::
1. Bulb burnt out. 1. Replace bulb - Pg. 12.
Lo se ict i i : 92_# rest;
1. Carpet height setting is
incorrect.
2. Blockage.
_Lo _ 6 _ cti :
1. Set Carpet Height Adjustment knob to
appropriate setting for carpet being cleaned
-Pg. 7.
2. Remove blockage - Pg. 11
1. Belt broken or stretched. 1. Replace brushroll belt - Pg. 12.
_ roiii i_: i_re ve ifro roi) _
13