Owner Manual

14
Maintenance
Belt Replacement
Remove the 6 screws as shown
with a Phillips screwdriver.
Remove the bottom plate.
Remove the used belt from the
brush roll (A) then from the
motor shaft (metal rod) (B) and
discard.
2
Ensure that the letters print-
ed on the belt are facing
you, slide the new belt over
the motor shaft (metal rod)
(C). Then slip it around the
area of the brush roll where
no bristles are present (D).
3
With the belt in place, pull the belt and
slide the brush roll into the nozzle making
sure that the brush roll end caps are in
the correct orientation. Place the bottom
plate aligning the screw holes and re-
install the 6 screws.
4
1
WHEN TO REPLACE
Replace the belt if it is damaged, cut or
broken. Refer to the directions below.
HOW TO REPLACE
Place the handle in the low position and
turn the cleaner over so the bottom side
is up.
CAUTION
To reduce the risk of injury from moving parts, unplug before servicing.
A
B
C
D