User Instructions

ManualsBrandsHoover ManualsAppliancesWasher Dryer Combo

The option buttons should be selected before pressing the

START button.

If an option is selected but it is not compatible with the

selected programme then the symbol first flashes and then

goes off.

NIGHT & DAY BUTTON

Press this button to reduce the intermediate spin speed to 400

rpm, where applicable; the water level is increased during

rinsing and the washing is kept immersed in water after the

final rinse in order to spread the fibres evenly.

During the phase in which the water is held in the tub, the

indicator lights to show that the machine is at a standstill.

Release the button to end the cycle with a spin dry (which

may be reduced or cancelled using the appropriate button)

and emptying phase.

Thanks to electronic control, the water in the intermediate

phases is emptied silently, making this option very useful for

washing at night.

PREWASH BUTTON

This option is particularly useful for heavily soiled loads and

can be used only on some programmes as shown in the

programmes table.

Detergent for this programme should be added to the

compartment of the soap drawer labelled “1” (Please refer to

Detergent Drawer Section of manual).We recommend you

use only 20% of the recommended quantities shown on the

detergent pack and fabric conditioner should not be used for

this programme.

STAIN BLASTER BUTTON

By pressing this button, a sensors system come into operation.

They affect both the selected temperature, keeping it at a

constant level throughout the wash cycle,and the

mechanical function of the drum.

The drum is made to turn at two different speeds at crucial

moments. When the detergent enters the garments, the drum

rotates in such a way that the detergent is distributed in a

uniform manner; during the wash and rinse procedures,

however, the speed increases in order to maximise the

cleaning action.Thanks to this special system,the efficiency of

the wash procedure is improved WITHOUT ANY INCREASE IN

THE LENGTH OF THE PROGRAM.

WASH TEMPERATURE BUTTON

When a programme is selected on the display is show the

recommended wash temperature.

The temperature button can be used to decrease or increase

the temperature of your chosen wash cycle.

Each time the button is pressed, the new temperature level is

shown on the display.

WASH TIME BUTTON

By selecting this button (active only on COTTON and MIXED

FIBRES programmes) there is a choice of 3 levels of wash

intensity, depending on how much the fabrics are soiled.

Once the programme has been selected the indicator light

will automatically show the minimum level required for that

programme. Pressing the button increases the duration of the

wash cycle, and adjusts the wash settings accordingly. For

example: Using this button on the Rapid Wash cycle will

enable you to select either a 14, 30 or 44 minute wash cycle.

DELAY START BUTTON

This button allows you to pre-programme the wash cycle to

delay the start of the cycle for up to 24 hours.

To delay the start use the following procedure:

Switch on the appliance by the ON/OFF button

Select the required programme.

Press the button once to activate it (h00 appears on the

display) and then press it again to set a 1 hour delay (h01

appears on the display); the pre-set delay increases by 1

hour each time the button is pressed, until h24 appears on

the display, at which point pressing the button again will

reset the delay start to zero.

Confirm by pressing the “START/PAUSE” button (the light on

the display starts to flash). The countdown will begin and

when it has finished the programme will start automatically.

It is possible to cancel the delay start by taking the following

action:

Press and hold the button for 5 seconds until the display will

show the settings for the programme selected.

At this stage it is possible to start the programme previously

selected by pressing the START/PAUSE button or to cancel

the process by pressing the ON/OFF button.