Manual

This product contains no serviceable parts. Do not try to repair it yourself. Any servicing that requires
disassembly other than cleaning must be performed by a qualified appliance repair technician.
ALL servicing should be done by an authorized service representative.
CLEANING MICROFIBER
CLEANING PADS
= Machine washable on "warm ° setting, Always
use a mild detergent.
i For best care results, lay fiat to dryr
• After the steamer is used, turn power off and then unplug the power cord.
• Over sink or drain, press down the steam trigger to release all pressure.
• Wait 7-10 minutes until the safety pressure indicator has gone down, which indicates the steamer has
cooled. After 10 minutes, if the safety pressure indicator has not fully dropped, release residual steam
pressure by pressing trigger and then gently pushing the safety pressure indicator. Slowly unscrew the
water fill safety cap counter-clockwise, but do not remove. Allow machine to cool an additional 5
minutes. After you have ensured the steamer has cooled and pressure has been released, the water
fill safety cap should turn freely for removal. Unscrewthe cap completely (3.5).
• Unplug the Hose/Handle Assembly f_m the steam port on the canister. If the unit is under pressure, it
may release residual steam and/or water that may have built up during use. If this happens, grab the
connector end of the Hose/Handle Assembly and place inside sink or towel to release contents.
• Empty the residual water in the tank and clean the external surface with a dry cloth. Allow to dry.
Re-install the water fill safety cap in a cloc,,_vise direction and tighten until completely sealed. DO NOT
OVER TIGHTEN, over tightening may make it more difficult to remove the cap at the next use.
• Leaving unused solution in solution tank wll[ not affect performance.
• Stare product in a protected, dry area. Keep water funnel and measuring cup for future use.