Adventure 2 Plus Adventure 3 Plus TREADMILL OWNER’S MANUAL Read the treadmill guide before using this owner’s manual.
ASSEMBLY WARNING There are several areas during the assembly process that special attention must be paid. It is very important to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have frame parts that are not tightened and will seem loose and may cause irritating noises. To prevent damage to the treadmill, the assembly instructions must be reviewed and corrective actions should be taken.
TOOLS INCLUDED: IPOD/MP3 PLAYER POCKET SPEAKERS (ADVENTURE 3 PLUS ONLY) ALL MODELS TOUCH PAD PANEL AND DISPLAY WINDOWS CONSOLE FF FF FF FF 6 mm T-Wrench 5 mm L-Wrench 4 mm T-Wrench 4 mm L-Wrench WATER BOTTLE HOLDER SAFETY KEY PLACEMENT GRIP PULSE HANDRAILS SUPPORT BAR ON/OFF SWITCH CIRCUIT BREAKER CONSOLE MAST FOOT LOCK LATCH (UNDERNEATH DECK) MOTOR COVER POWER CORD PARTS INCLUDED: FF FF FF FF FF FF FF FF 1 Console Assembly 2 Console Masts 2 Socket 1 Support Bar 5 Hardware Bags 1 Safety Key 1 A
ASSEMBLY STEP 1 ASSEMBLY STEP 2 HARDWARE BAG 1 CONTENTS : ALL MODELS SOCKET BOLT 10 mm Qty: 8 A Open hardware bag 1. B Cut the yellow banding and get console mast out C Attach the LEFT SOCKET to the LEFT console mast using 4 SOCKET bolts (a). D A HARDWARE BAG 2 CONTENTS : BOLT (A) 20 mm Qty: 4 SPRING WASHER (B) 15 mm Qty: 4 FLAT WASHER (C) 15 mm Qty: 4 Attach the RIGHT SOCKET to the RIGHT console mast using 4 SOCKET bolts (a). Lift the running deck upward until the foot latch locks.
ASSEMBLY STEP 3 ASSEMBLY STEP 4 HARDWARE BAG 3 CONTENTS : ALL MODELS BOLT (A) 20 mm Qty: 4 SPRING WASHER (B) 15 mm Qty: 4 FLAT WASHER (C) 15 mm Qty: 4 A Open hardware bag 3. B Pull lead wire through right console mast. After pulling the lead wire through the mast, the top of the console cable should be located at the top of the mast. Detach and discard the lead wire.
ASSEMBLY STEP 5 ASSEMBLY STEP 6 HARDWARE BAG 3 CONTENTS : ALL MODELS BOLT (A) 15 mm Qty: 4 A Open hardware bag 5. B Align SUPPORT BAR with holes in CONSOLE MASTS. C Insert BOLTS (H) into all 4 holes of the SUPPORT BAR. ALL MODELS Note: Look into holes in the right mast before inserting bolts to avoid pinching cables.
TREADMILL OPERATION This section explains how to use your treadmill’s console and programming.
Adventure 2 PLUS and Adventure 3 Plus CONSOLE OPERATION H J B A ALL MODELS R S M I M TIME DISTANCE ZEIT TARGETS ZIELE K ENTFERNUNG TIME ZEIT DISTANCE ENTFERNUNG CALORIES INCLINE KALORIEN SPEED STEIGUNG ENERGY SAVER ENERGIESPARMODUS GESCHWINDIGKEIT CALORIES KALORIEN HEART RATE HERZFREQUENZ INCLINE STEIGUNG 1% 2% GESCHWINDIGKEIT 4% 6% 8% 4 km/h 10% 2 mph 10 km/h 8 km/h 5 mph 6 mph 12 km/h 7 mph SPEED 14 km/h 8 mph 18 km/h 11 mph INCLINE SPEED STEIGUNG GESCHWINDI
Display windows GETTING STARTED 1) Check to make sure no objects are placed on the belt that will hinder the movement of the treadmill. Adventure 2 Plus and Adventure 3 Plus DISPLAYS TIME TARGETS ZIELE DISTANCE ZEIT 2) Plug in the power cord and turn the treadmill ON. CHANGING YOUR TARGET MID-WORKOUT 3) Stand on the side rails of the treadmill. You can change your Target “on-the-fly” without losing your current workout stats.
TARGET PROFILES TARGET 1 – TIME: Allows user to set a target based on how long they would like to workout. Time targets can range from 15:00 – 99:00. TIME will count down. DISTANCE and CALORIES will count up from zero. TARGET 2 – DISTANCE: Allows user to set a target based on distance they would like to complete. Distance target can range from 0.25 – 26.25 MILE or 0.4-42 KM. DISTANCE will count down. TIME and CALORIES will count up from zero.
To reset the console Hold stop key for 3 seconds. COOL DOWN Puts treadmill into cool down mode. Cool down lasts for four minutes and reduces speed and incline to allow your heart to readjust to decreased demand. Finishing your workout When your workout is complete, the monitor display will flash “FINISHED” and beep. Your workout information will stay displayed on the console for 30-45 seconds and then reset.
TREADMILL OWNER’S MANUAL Adventure 2 Plus & Adventure 3 Plus Treadmill Owner’s Manual 052011 Rev1.
