Owner's manual

7
II. Installation and Operating Instructions
WARNING
1. This icemaker must be installed in accordance with all applicable national,
state, and local regulations.
2. CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews
are securely in place after installation. Make sure that none have fallen into
the storage bin.
A. Checks Before Installation
•Visuallyinspecttheexterioroftheshippingcontainerandimmediatelyreportany
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
•Removetheshippingcarton,tape,andpackingmaterial.Ifanyareleftintheicemaker,
it will not work properly.
•Removethefrontpaneltopreventdamagewheninstallingtheicemaker.See"II.B.
How to Remove Panels."
•Removethepackagecontainingtheaccessories.
•Removetheprotectiveplasticlmfromthepanels.Iftheicemakerisexposedtothe
sun or to heat, remove the lm after the icemaker cools.
•Checkthattherefrigerantlinesdonotrubortouchlinesorothersurfaces,andthatthe
fan blade turns freely.
•Checkthatthecompressorissnugonallmountingpads.
•Seethenameplateontherearpanel,andcheckthatyourvoltagesupplied
corresponds with the voltage specied on the nameplate.
B. How to Remove Panels
See Fig. 1
•FrontPanel:Removethescrew.Liftupandtowards
you.
•TopPanel:Liftupatthefrontslightly,pushrearward,
and lift off.
•SidePanels:Removethescrew.Slideforwardslightly
and lift off.
Fig. 1
Top Panel
Front Panel
Left Side Panel
Right Side Panel