User guide

11
5) Install the bin control thermostat as follows:
a. Remove the baffle from the bin.
b. Remove the tie securing the bin control thermostat assembly. Remove the
2thumbscrewsandthe"Z"bracket.
c. Remove the bin control thermostat assembly from the shipping hook by lifting it up
and shifting it to the right. Lower the thermostat extension bracket (stainless) with
the thermostat bulb attachment and thermostat bulb through the hole located at the
bottom of the icemaker. Next, lower the thermostat bracket (plastic) through the hole.
Fig. 3
Bin Control Thermostat Assembly
Shipping Hook
Thermostat Bracket
(plastic)
Tie
"Z"Bracket
Thermostat Bulb
Attachment (plastic)
and Thermostat Bulb
Thumbscrews
Thermostat Extension
Bracket (stainless)
Hole
Wall
d. Slide the left side of the upper part of the assembly towards you and make sure it
is hooked on the wall. Make sure the left side and bottom of the assembly are ush
against the wall and base panel.
e. Secure the assembly in place with the thumbscrews (unless you are installing a
second unit).
f. Insert the plug into the receptacle on the assembly until it locks into place.
If a Hoshizaki B-800, B-900, or B-1150 bin is used:
g.Putasidethe"Z"bracket;itisnotneededwiththebinslistedabove.
h. Remove the 2 screws from the lower part of the thermostat bracket (plastic) and use
them to attach the thermostat extension bracket (stainless) to the thermostat bracket
(plastic).
Thermostat Bracket
(plastic)
Thermostat Extension
Bracket (stainless)
Fig. 4
Plug
Receptacle
Thumbscrews
Hook
Bushing