User guide

12
If a Hoshizaki B-1300, B-1500, B-1650, or non-Hoshizaki bin is used:
g. Remove the 2 screws securing the thermostat bulb attachment (plastic) to the
thermostatextensionbracket(stainless).Usethe2screwstoattachthe"Z"bracket
(plastic) to the thermostat extension bracket (stainless).
h. Use the two 4×10 stainless steel screws in the accessory bag to attach the
thermostatbulbattachment(withattachedthermostatbulb)tothe"Z"bracket.
i. Remove the 2 screws from the lower part of the thermostat bracket (plastic) and use
them to attach the thermostat extension bracket (stainless) to the thermostat bracket
(plastic).
6) Level the icemaker and storage bin in both the left-to-right and front-to-rear directions.
Adjust the storage bin legs to make the icemaker level.
7) Replace the panels and baffle in their correct positions (unless you are installing a
secondunit).(See"E.InstallationofSecondUnit.")
E. Installation of Second Unit
1)See"II.D.Setup"forthelowerunitinstallation.
2) Remove the top panel and the top insulation of the lower unit. The top panel and the
top insulation of the lower unit are not required when installing the second icemaker.
3) Unpack the second icemaker (upper unit), and remove the shipping carton, tape, and
packing material.
4) Remove the panels of the second icemaker.
5) Stack the upper unit on top of the lower unit.
6) Secure the upper unit to the lower unit using the 2 mounting brackets and the bolts
provided.
Thermostat Bracket
(plastic)
Thermostat Bulb
Attachment (plastic)
"Z"Bracket(plastic)
Thermostat Extension
Bracket (stainless)
Fig. 5
Mounting
Brackets
Bolts
Bin
Icemaker
(Upper
Unit)
Icemaker
(Lower
Unit)
Fig. 6