User guide

c. Make sure the male tting and female coupling are properly aligned, then start the

connection by hand to ensure that it is not cross threaded.

d. Tighten the connection with a wrench until it is tight. At this point, the nut has

covered most of the threads on the male tting.

e. Mark a reference line on the female coupling and the remote condenser unit or

icemaker panel. Using a backup wrench on the back of the female coupling, tighten

the six-sided nut of the female coupling an additional 1/6 turn. See Fig. 13.

Fig. 11

THREAD

SEALANT

Threads

Diaphragm

O-Ring

Fig. 12

Fig. 13

POLYOL

ESTER

(POE) OIL

PARKER

SUPER

O LUBE

Brush

Male Fitting

Apply POE Oil to

Entire Male Fitting

DO NOT USE

THREAD SEALANT

Backup

Wrench

Reference Line

1/6 Turn

Wrench

Backup

Wrench

After Tight, Tighten an

Additional 1/6 Turn

Female Coupling

5/8"ODDischargeLine

(Insulated)

Remote Condenser Unit

3/8"ODLiquidLine

(Insulated)

Icemaker

Male Fitting

Service Loop