User guide

9
II. Installation and Operating Instructions
WARNING
1. This icemaker must be installed in accordance with applicable national, state,
and local regulations.
2. CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews
are securely in place after installation. Make sure that none have fallen into
the storage bin.
A. Checks Before Installation
•Visuallyinspecttheexterioroftheshippingcontainerandimmediatelyreportany
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
•Removetheshippingcarton,tape,andpackingmaterial.Ifanyareleftintheicemaker,
it will not work properly.
•Removethepanelstopreventdamagewheninstallingtheicemaker.See"II.B.Howto
RemovePanels."
•Removethepackagecontainingtheaccessories.
•Removetheprotectiveplasticlmfromthepanels.Iftheicemakerisexposedtothe
sun or to heat, remove the lm after the icemaker cools.
•Checkthattherefrigerantlinesdonotrubortouchotherlinesorsurfaces.
•Checkthatthecompressorissnugonallmountingpads.
•Seethenameplateontherearpanel,andcheckthatyourvoltagesupplied
corresponds with the voltage specied on the nameplate.
•Thisicemakercanbeinstalledonastoragebin48"wideorwider.HoshizakiIce
Storage Bin, Model B-800 series is recommended. For further options, contact your
local Hoshizaki distributor.
•Onremoteair-cooledmodel,aremotecondenserunitisneeded.HoshizakiRemote
Condenser Unit, Model URC-22F is recommended.
B. How to Remove Panels
See Fig. 1
•FrontPanel:Removethe2screws.Liftupand
towards you.
•TopPanel:Removethe2screws,andliftoff.
•SidePanel(R):Removethescrew.Slideforward
slightly and lift off.
•InsulationPanel:Removethethumbscrew.Liftup
slightly and pull towards you.
Fig. 1
Top Panel
Insulation
Front Panel
Side Panel (R)