User Guide

HotBrick, Tel: 305

398

0888, Fax: 305

398

5966

Installing the Dual WAN VPN Firewall on your LAN

Figure 2-4: Installation Diagram

13. Ensure the Dual WAN VPN Firewall and the DSL/Cable modem are powered OFF.

Leave the modem or modems connected to their data line.

14. Connect the Broadband modem or modems to the Dual WAN VPN Firewall.



If using only one (1) Broadband modem, connect it to WAN port 1.

Use the cable supplied with your DSL/Cable modem. If no cable was supplied, use a

standard cable.

15. Use standard LAN cables to connect PCs to the LAN ports on the Dual WAN VPN Firewall.

Both 10BaseT and 100BaseT connections can be used simultaneously.

If you need to connect the Dual WAN VPN Firewall to another Hub, use a standard

LAN cable to connect any LAN port on the Dual WAN VPN Firewall to a standard port on

another hub. Any LAN port on the Dual WAN VPN Firewall will automatically act as an

"Uplink" port when required.



If a device is set to 2 WAN ports from port 1 to 2, the others are LAN ports from port 3 to

16.

16. Power Up

Power on the Cable or DSL modem or modems.

Connect the supplied power cord to the Dual WAN VPN Firewall and power up.

17. Check the LEDs



The Power LED should be ON.



The Link/ACT LED should be ON, if the corresponding WAN port is connected to a

broadband modem.



For each PC connected to the LAN ports, the corresponding LAN LED (either 10/Yellow or

100/Green) should be ON.