User Guide

HotBrick, Tel: 305

398

0888, Fax: 305

398

5966

3 : Loadbalancing

This screen is only operational if using Internet connections on both WAN ports

Figure 3-2: Load Balance

Load balancing – Load Balancing

Enable – Use this to enable your Load Balance settings. Unless this is checked, the other

settings on this screen have no effect.



Balance Type – Select the desired option:

• Bytes rx+tx – Traffic is measured by Bytes.

• Packets rx+tx – Traffic is measured by Packets.

• Sessions established – Traffic is measured by Sessions.

• IP Address – Traffic is measured by IP Address.

Loading Share on WAN 1 – Enter the percentage (%) of traffic to be sent over WAN 1. If one

WAN port connection has greater bandwidth than the other, the one with the greater bandwidth

should be given a higher percentage of traffic than the other.

NAT statistics This section displays the current data about WAN 1 and WAN 2. You can use this

information to help you "fine-tune" the settings above.

Interface statistics This section displays cumulative statistics. Use the "Restart Counters" button

to restart these counters when required.