Owner's manual

How to operate the CMC computer control

Starting up: The oven always starts in the manual menu with the HOT AIR mode automatically

selected.

MANUAL OPERATION

This function is activated by pressing ON/OFF. The pilot lamps change from red to green to

indicate that the function is active.

Changing operating mode, time, etc.

If another operating mode than HOT AIR is required, this must be selected before selecting

time, temperature, etc. If not, these settings will be deleted by the settings of the new operating

mode.

Before starting or during program performance, you can change the time, temperature, core

temperature, exhaust and fan speed as you please.

Time, temperature and core temperature is selected by pressing the function key in question, and the

text in the display will flash. Changes can now be made by pressing the keys. Confirm with

ENTER-STEP .

The exhaust is open when the pilot lamp is on . High fan speed is indicated by the upper pilot

lamp, low fan speed by the lower pilot lamp .

Timer

The oven has a timer function that can be used to count down the time when you preheat the oven

or for automatically starting a program.When the time runs out, an alarm will sound and the oven

will continue in the next step.

Activate the timer function in a manual operation mode by pressing the key for fan speed. The

display shows “Timer function” and you can set the time. Press ENTER-STEP and start

programming the desired functions as described under “Extending a program”, and press ON/OFF.

Extending a program

To extend a program by another step, press ENTER-STEP and the vacant step is ready for

programming.

In short:-

1. Choose one of the six operating modes as step 1.

2. Adjust the values for time, temperature and core temperature, if necessary. Perhaps, change the

settings for fan and exhaust.

3. Proceed to the next step or start the oven program.