Installation & Assembly

ASSEMBLING ＆ INSTALLATION INSTRUCTIONS PRODUCT
W
ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2)
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the old fixture, including the mounting
hardware.
2. Carefully unpack the new fixture and lay all the parts on a clear
area. Take care not to lose any parts necessary for installation.
3. Attach the loop (I) to the column (J) by turning it clockwise until
tight. Attach the rod (K) to the column (J) and the fixture body
(M) by turning it clockwise until tight.
HANGING THE FIXTURE (Fig.1)
4. Thread the nipple (C) into the loop (F) until snug.
5. Thread the other end of the nipple (C) with the loop attached
into the crossbar (D) until snug.
6. Place the lock washer (B) over end of the nipple (C) protruding
through the crossbar and thread the hex nut (A) onto the nipple
until tight.
7. Take the crossbar assembly and mount to ceiling junction box
with the junction box screws (E). Tighten the screws securely
with a screwdriver.
8. Use proper chain pliers to open one end link of the chain and
connect it to the fixture loop (I); then close the link.
9. By measuring, determine correct number of links needed for
proper hanging height. Using proper chain pliers to disconnect
and discard remaining chain.
10. Lace the fixture wires through the chain.
11. Slip loop collar (H) and the canopy (G) over the chain.
12. Open the other end link of the chain and hang the fixture on the
loop at the ceiling. Close the link.
13. Feed the fixture wires through the loop (F) and nipple (C) and
pull until tight.
CONNECTING THE WIRES (Fig.3)
14. Connect the electrical wire as shown in figure 3, making sure
that all wire connectors are secured. If your outlet has a ground
wire (green or bare copper), connect the fixtures ground wire to
it. If the junction box has no ground wire, attach the bare copper
fixture wire to the green ground screw on the crossbar. Tuck the
wire connections neatly into the ceiling junction box.
COMPLETING THE INSTALLATION (Fig.1 and Fig.2)
15. Raise the canopy (G) all the way to the ceiling; then raise the
loop collar (H) and thread into ceiling loop protruding through
canopy.
16. Hook the end of long crystals (Q) to the bottom loop of the
column (J) and the top hole of the fixture body (M).
17. Hook the end of short crystals (P) to the bottom hole of the
fixture body (M) and the top hole of the column (N).
18. Hang the crystals (R) to the top hole of the column (J). Hang the
crystals (O) to the bottom hole of the column (N).
19. Place the tube (L) over the socket of the fixture body (M).
20. Install the light bulbs (not included) in accordance with the
fixture’s specifications: DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the junction box
and test the fixture.
Fig.1
Fig.2
Fig.3
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE