Manual

Figure 38 Re

moving a power supply

Installing a power supply

1. Lift up on the module latch (1, Figure 39) and slide the power s upply into the enclosure until it is

fully seated.

2. Connect the power cord to the p ower supply and engage the c ord lock.

Figur

e 39 Ins ta lling a power supply

V erify ing proper operation

After replacing the power supply or blower, check the following to verify that the component is operating

properly:

NOTE:

It may take up to 10 minutes for the component to display good status.

• Make sure the blower begins op erating immediately.

• The status indicator should be on.

Customer replaceable units