Owner's manual

72
• The coordinate conversion (Pol, Rec) functions cannot be
used for a number table generation function.
• Note that the number table generation operation causes
the contents of variable X to be changed.
Start, End, and Step Value Rules
• Linear format is always used for value input.
• You can specify either values or calculation expressions (which
must produce a numeric result) for Start, End, and Step.
• Specifying an end value that is less than the Start value
causes an error, so the number table is not generated.
• The specified Start, End, and Step values should produce
a maximum of 30 x-values for the number table being
generated. Executing a number generation table using a
Start, End, and Step value combination that produces
more than 30 x-value causes an error.
Note : Certain functions and Start, End, Step value
combinations can cause number generation to take a long time.
Number Table Screen
The number table screen shows x-values calculated using the
specified Start, End, as well as the values obtained when
each x-value is substituted in the function f(x).
• Note that you can use the number table screen for viewing
values only. Table contents cannot be edited.
• Pressing the
 key returns to the function editor screen.
TABLE Mode Precautions
Note that changing the input/output format settings (Math format
or Linear format) on the calculator’s setup screen while in the
TABLE Mode clears the number table generation function.
Using the Verify Command
Use the  key to enter the VERIF Mode when you want to
compare and check two values.
Key in Display

